Bluetooth Module for DT590 Cordless Telephone User Guide Cover Page Graphic Place the graphic directly on the page, do not care about putting it in the text flow. Select Graphics > Properties and make the following settings: • Width: 15,4 cm (Important!) • Height: 11,2 cm (May be smaller) • Top: 5,3 cm (Important!) • Left: -0,3 cm (Important!) This text should then be hidden.
EN/LZT 103 017 R2A © Aastra Telecom Sweden AB 2008. All rights reserved.
Table of Contents Table of Contents page Welcome .......................................................... 4 Description ....................................................... 6 Installation ........................................................ 7 Operation ....................................................... 16 Maintenance ..................................................
Welcome Welcome This User Guide shows you how to install the Bluetooth module in the DT590 cordless phone and how to pair and operate the telephone with a Bluetooth headset. The Bluetooth module is placed in the battery compartment and connected with a connector. Bluetooth technology replaces the cord between the cordless phone and the headset. This allows the user to move more freely and eliminates the risk of a headset cord getting stuck. Bluetooth module supports the Bluetooth 1.2 standard.
Welcome Copyright All rights reserved. No parts of this publication may be reproduced, stored in retrieval systems, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior written permission of the publisher except in accordance with the following terms.
Description Description The Bluetooth module is a small flat electronic board with an integrated antenna moulded into plastic and a connector. The Bluetooth module can be easily installed in the battery compartment. Article number: DPY 901 549/1 Note: To use the Bluetooth module your phone has to fulfill certain hardware and software requirements. The minimum hardware version is R2A. The hardware version is found on the label under the battery (next to the article number 1/DPNANB 240 01/1).
Installation Installation Turn off the phone by pressing NO until the display goes blank. Cordless DT590 Bluetooth 1 Remove the battery cover. 2 Completely remove the foam on the inside of the battery lid. 3 Connect the Bluetooth module connector to the largest connector on the phone. As the connector is asymmetric it is not possible to connect the module in the wrong way. 4 Remove the backing paper from the tape on the Bluetooth module.
Installation 8 Cordless DT590 Bluetooth
Installation Headsets Since the Bluetooth module supports the Bluetooth 1.2 standard, any headset that comply to this standard can be connected to the phone. Note: As your Bluetooth headset may have more or less functions than described here, please refer to the user guide for the Bluetooth headset. Wear 026 For optimal performance wear the Bluetooth headset and the phone on the same side of your body.
Installation Setup ¾ º º ÜÛ º ÜÛ Enable Bluetooth Press. Select the “Toolbox” tab. Select the menu item ”Bluetooth” and confirm. The following options are available: • Enable • Headset (greyed out) Select the menu item ”Enable” and confirm. The menu options now change to: • Disable • Headset (active) The activated Bluetooth function will be indicated by a symbol ( in the info row of the display.
Installation ÜÛ º ÜÛ ¿ ÜÛ Put the headset in pairing mode (please refer to the user guide of the headset) and confirm on the phone. The phone starts to search for the headset. When headset is found it is displayed in the phone menu with its supplier specific name. Select the headset and confirm. The pairing starts. After a few seconds a PIN-code is requested for the Bluetooth headset. Enter the PIN-code (please refer to the user guide of the headset) and confirm.
Installation Activate a Bluetooth headset ¾ º º ÜÛ º ÜÛ º ÜÛ º ÜÛ This chapter is only relevant when you have paired more than one headset and you want to switch between them (only one headset can be active at the time). Press. Select the “Toolbox” tab. Select the menu item ”Bluetooth” and confirm. Select the menu item ”Headset” and confirm. Select the desired headset and confirm. The following options are available: • Connect • Edit name • Remove Select the menu item ”Connect” and confirm.
Installation Deactivate a Bluetooth headset ¾ º º ÜÛ º ÜÛ º ÜÛ º ÜÛ Cordless DT590 Bluetooth To deactivate the active Bluetooth headset proceed as follows. Press. Select the “Toolbox” tab. Select the menu item ”Bluetooth” and confirm. Select the menu item ”Headset” and confirm. Select the desired headset and confirm. The following options are available: • Disconnect • Edit name • Remove Select the menu item ”Disconnect” and confirm.
Installation Remove a headset ¾ º º ÜÛ º ÜÛ º ÜÛ º ÜÛ 14 To remove a Bluetooth Headset proceed as follows Press. Select the “Toolbox” tab. Select the menu item ”Bluetooth” and confirm. Select the menu item ”Headset” and confirm. Select the desired headset and confirm. The following options are available: • Disconnect or Connect • Edit name • Remove Select the menu item ”Remove” and confirm.
Installation Change the name of Bluetooth headset ¾ º º ÜÛ º ÜÛ º ÜÛ º ÜÛ Cordless DT590 Bluetooth The bluetooth headset reports its default name to the phone (normally the type name of the headset). To change the name proceed as follows. Press. Select the “Toolbox” tab. Select the menu item ”Bluetooth” and confirm. Select the menu item ”Headset” and confirm. Select the desired headset and confirm.
Operation Operation ¿ Ü Û ÚÙ Make a call with the headset Enter the desired number. The number is displayed. Press when the number is correct. Press when “Transfer call to phone?” is displayed. The call is transferred to the Bluetooth headset If you want to use the phone instead, press ÜÛ. Answer a call with the headset A ring signal sounds in both the active Bluetooth headset and the phone to signal an incoming call. Press the button on the headset, if the call shall be answered on the headset.
Operation Transfer a call from the headset to the phone º º ÜÛ º ÜÛ To transfer a call from the Bluetooth headset to the phone proceed as follows: Select the “Ongoing call” tab. Select the menu item “Audio transfer” and press. Select the menu item “To phone” and press. Transfer a call from the phone to the headset º º ÜÛ º ÜÛ To transfer the call from the phone to the Bluetooth headset proceed as follows: Select the “Ongoing call” tab. Select the menu item “Audio transfer” and press.
Operation Operation notice Accessibility and Voice quality Bluetooth uses the frequency of 2.45 GHz. WLAN, microwave oven and other devices that use the same frequency can cause a disturbance in the Bluetooth headset. Operation Area The maximum operating distance between the headset and the phone is 10 metres according to standard 1.2. The communication distance between the handset and headset may vary considerably due to the environment and disturbances from other 2.45 GHz equipment.
Maintenance Maintenance Replace the battery Carefully remove the Bluetooth module from the battery. Replace the Battery (see chapter “Replacing the battery” on page 125) and fasten the Bluetooth module again (see chapter “Installation” on page 7. Replace the Bluetooth module The Bluetooth module is not reparable. Ensure that it is properly disposed of.
Maintenance Trouble Shooting Problem No headset found Pairing fails Connecting fails/ Failed to connect headset 20 Reason Headset is turned off Headset is out of battery Headset is out of range Headset is not in pairing/ discoverable mode Incorrect PIN entered Headset is not turned on Headset is out of range Link key in headset has been deleted Headset is already connected to another phone Too close to a WLAN area and headset does not support the Bluetooth standard v1.
Maintenance Problem Headset cannot connect to phone Reason Phone is not turned on Phone is out of range Bluetooth module is disabled. Another headset is already connected to the phone. Link key is missing in either headset or phone. Too close to a WLAN area and headset does not support the Bluetooth standard v1.
Notes Notes 22 Cordless DT590 Bluetooth
Notes Cordless DT590 Bluetooth 23
Subject to alteration without prior notice. For questions regarding the product, please contact your Aastra certified Sales Partner. Also visit us on http://www.aastra.com © Aastra Telecom Sweden AB 2008. All rights reserved.
