User manual

27/1531-ANF 901 43 C 2014-01-12
Configuration Manual Cordless Phones DT4X3
2
2.1 WinPDM
The Windows Version is run on a PC. The handset is configured via WinPDM as
follows:
1 Connect a Desk PDM Charger or a Rack PDM Charger via USB to the computer
running WinPDM.
2Start WinPDM.
3 Place the handset in this charger which shall be connected to WinPDM. The
handset can either be turned off or turned on when placing it in the charger. A
handset that is turned off will start up automatically and the battery charging
symbol will be displayed.
For instructions on how to use WinPDM, see its Installation and Operation Manual.
Figure 1. Configuration of handsets via WinPDM.
2.2 Device Manager in CPDM3
The CPDM3 runs on an ELISE3 module.
For instructions on how to use the CPDM3, see the corresponding Installation and
Operation Manual.
2.2.1 Via Chargers
1 Connect a Desk PDM Charger or a Rack PDM Charger via the Ethernet port to
the network.
2 The charger is by default configured to connect to the network using DHCP. If
DHCP is not used in the network, connect each charger via USB to a WinPDM
and configure a static IP address.
3 Start the CPDM3.
4 Place the handset in a charger that is connected to the CPDM3. The handset
can either be turned off or turned on when placing it in the charger. A handset
that is turned off will start up automatically and the battery charging symbol will
be displayed
Figure 1.
PDM
001