User manual

27/1531-ANF 901 43 C 2014-01-12
Configuration Manual Cordless Phones DT4X3
41
7 Troubleshooting
This section contains information on how to solve common operational problems, and
information on warnings you may receive.
Go through the following lists if you encounter any problems. If this checklist does not
solve the problem, contact the system administrator.
If other users have similar problems, there may be a system error.
7.1 Fault Symptoms
If any of the following Fault Symptoms occur, follow the instructions below.
7.2 Display Information
The following error messages can be shown in the handset display:
Fault Probable cause Action or comment
The display stays dark Low battery level or
faulty handset.
Charge the battery. If the
handset does not work after
charging, contact the system
administrator.
There is no ring signal The handset is muted, the ring
volume is set to silent, or faulty
handset.
Press and hold the Mute key, or
increase volume (Settings >
Sound & Alerts > Volume) or
contact the system
administrator.
Display shows Probable cause Action or comment
No access The handset is in range, but has
no access rights.
Switch off the handset and then
switch it on again. If this does
not work, contact the system
administrator.
No System.
The handset beeps once a
minute with a low tone
followed by a high tone
(during max 30 minutes). If the
vibrator is enabled, it vibrates
after the last beep.
The handset is out of coverage,
or faulty handset.
The beeps can be stopped with
the mute button. Then go into
range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
If this does not work,
contact the system
administrator.
SERVICE NEEDED
Parameters corrupt
Note: This display message is
only shown in English.
Faulty handset. Select the reset option on the
middle soft key. If this is not
available or the problem
persists send the handset for
service.
No flash driver was found
Note: This display message is
only shown in English.
Failed to read from flash Send the handset for service.