User manual

27/1531-ANF 901 43 C 2014-01-12

Configuration Manual Cordless Phones DT4X3

5.31.1 Selection of Headset Type (Corded Headset)

In order to achieve optimal audio quality with the different headset types, it is

recommended to set the corresponding headset type. The default setting is

"microphone on a boom", which means that the audio is optimized for using a headset

with microphone on a boom. The headset type can be changed as follows:

1 Select Connections > Headset.

2 In the Headset type drop-down list, select the corresponding headset type to be

used.

If "User headset profile" is selected, continue with chapter User headset profile.

User headset profile

If the preconfigured headset profiles does not match the headset or the audio

performance is bad, it is possible to configure a headset profile.

1 Select Connections > Headset > User headset profile.

2 In the Name of user headset profile field, enter an appropriate name. The name

will be visible and selectable in the handset menu.

3 In the Headset mic adjustment drop-down list, select the microphone gain to be

used.

4 In the Headset speaker adjustment drop-down list, select the speaker gain to be

used.

Note: Changing these parameters may result in a very high sound level which can

cause hearing damage. In addition, these parameters may result in lower sound quality

such as noise and echo. If the audio problems occur, it is noticeable for the person

listening on the conversation. Evaluate carefully before applying.

5.32 Display New Messages and Call Information Upside Down

New messages and information about incoming calls can be displayed upside down.

This can be useful if you wear the handset in a belt and want to read the message/call

information without rotating the handset. When pressing any key, the messages will be

displayed in the normal way.

1 Select Settings > Display

2 In the Rotate display text drop-down list, select one of the following:

• On - New messages and call information will be rotated 180 degrees.

• Off - Disables the rotation function.

5.33 Owner identification in the idle display

It is possible to add owner identification in idle mode of the handset. In a template or

Number, the parameter is found at:

Settings > Owner ID

Tip: It is also possible to configure the Owner ID via the handset menu. See the

handset´s User Manual.