User manual

27/1531-ANF 901 43 C 2014-01-12

Configuration Manual Cordless Phones DT4X3

• Man-down detection time

Determines when the warning phase will start after man-down is triggered.

• No-movement alarm

Determines if the No-movement alarm shall be enabled or disabled.

• No-movement detection time

Determines when the warning phase will start after No-movement alarm is

triggered.

• Warning phase duration

Determines the time before the warning phase is ended and the alarm is sent.

•ALS

• Automatic call after alarm mode

The call can be established in the following modes;

- Normal: the call is established as an ordinary call.

- Loudspeaking: the loudspeaker on the backside of the handset is turned on.

See also 5.22 Common Alarm Settings on page 28 for additional parameter settings.

Information about the handset’s location can also be sent along with an alarm, see 5.19

Base Station Location on page 28.

5.25 Sound Settings for Calls

It is possible to set the ring volume and ring signal for calls.

5.25.1 Set Ring Volume

1 Select Settings > Sound and Alerts.

2 In the Ring Volume drop-down list, select the ring volume to be used.

5.25.2 Set Ring Signal

1 Select Settings > Sound and Alerts.

2 In the call drop-down lists, select the ring signal to be used for the different calls.

3 In the Internal Call/External Call/Callback/PTT

Call drop-down lists; select the

ring signal to be used for the incoming call, respectively.

Tip: It is possible to create own ring signals, and then select the signal see

5.25.3 Create Custom Sound as Ring Signal.

5.25.3 Create Custom Sound as Ring Signal

The handset can play customized ring signals. The ring signals must first be

customized before it can be selectable in 5.25.2 Set Ring Signal.

Note: Custom sounds can also be used as message alerts. It is recommended to not

use same sounds as ring signals and message alerts in order to distinguish them from

each other. For more information how to use custom sound as message alert, see

5.26.1 Configure Message Alerts with Beep Codes on page 32.

1 Select Settings > Custom Sounds > Custom Sound X (where X represents 1 -

10).

1. The ALS will not be activated if an automatic call is established after an alarm has been sent.

2.This function requires 3rd party conference unit.