User manual

27/1531-ANF 901 43 C 2014-01-12

Configuration Manual Cordless Phones DT4X3

2 In the Call behaviour drop-down list, select one of the following:

• No action - no action will be performed when handset is placed in charger

• End - the handset will disconnect calls when placed in charger.

NOTE: Some systems/PBXs require that the handset sends a DTMF tone in order

to end a call, See 5.11.1 Send DTMF Tone when Pressing On-Hook key on page 24

for configuration.

5.16 Put on Loudspeaker - the handset will activate the loudspeaker mode when placed in

charger.

Clear Lists when inserted in Charger

The handset can be configured to clear lists when placed in a charger. The following

message and call lists will then be cleared:

• Inbox

• Unsent

• Sent

• Call list

• Missed calls

Using the WinPDM and the "Edit template" feature, the parameter can be found at

Connections > In_Charger > Clear_Lists_In_Charger

in a template or parameter definition file (.def).

The default setting for "Clear list in charger" is "Off". The feature is activated by

changing the parameter value to "On". When the feature is enabled, the lists are

cleared when the handset is placed in the charger.

5.17 Disable of Homebase GAP Registration

When the feature is disabled, it is not possible to register to a home base.

Using the "Edit template" feature in the WinPDM/CPDM3, the parameter can be found

Systems > Home_Base_Subscription.

The parameter shall be set to "Enable" for registration of a new homebase station. The

default value is "Disable".

5.18 Require Encrypted Base Station

The handset can be configured to set up calls via encrypted base stations only. This is

used to avoid snooping in the telephony network.

Requirements:

• The encryption is enabled in the base station. See corresponding manual for the

base station.

Using the "Edit template" feature in the WinPDM, the parameter can be found at:

Systems > Encryption required.

When the parameter is set to "Yes", only call setup via encrypted base stations are

possible. The default value is "No".