User manual

27/1531-ANF 901 43 C 2014-01-12
Configuration Manual Cordless Phones DT4X3
15
4 A dialog window appears, asking the user to decide whether to use the Number
settings in WinPDM or the Number settings in the device. Select "WinPDM".
The handset will automatically be synchronized and all data and parameter
settings will be transferred to the new handset. The synchronization will take a
while if the Contacts in the original handset contains a large number of contacts.
4.6.1 Handset Replacement with WinPDM in Integrated DECT System
1 Insert the new handset into a desktop charger or charging rack connected to the
WinPDM.
2 A dialog window will be displayed. Select the option "Associate with number".
Follow the instructions and select the number of the old handset, see WinPDM
Installation and Operation manual.
The handset will automatically be synchronized and all data and parameter
settings will be transferred to the new handset. The synchronization will take a
while if the Contacts in the original handset contains a large number of contacts.
3 Subscribe the new handset.
4.7 DECT Frequency Band Configuration
NOTE: The frequency band configuration is only needed if other frequencies than
EU,US or China shall be used. Additionally, if the handset has been returned from
repair, the applicable frequency band might be set again.
In order to change the operating frequency band, the following preconditions must be
fulfilled:
• The frequency is set to Not initiated. This can be checked by entering the Admin
menu, see 6 Administration on page 38, follow the path:
Admin menu > Device info > Hardware.
Scroll down to “Frequency band”.
• The handset must not have a DECT registration. If it already has, perform a Factory
reset, see 4.3 Perform a Factory reset on page 12.
1 Enter the Admin Menu, see 6 Administration on page 38.
2 Select "Frequency band" and select the desired band.
• EU US China (default)
• LA (Latin America)
• Brazil
• 1900 - 1920 MHz
3 Restart the handset.
4 Register the handset.
5 The frequency band option will no longer be available.
NOTE: The selection is persistent and will stand a factory reset.
4.7.1 Multiple Frequency Support
The handset can be used in a system that changes frequency by selecting
‚"Multifrequency‚" as frequency band in the handset. See 4.7 DECT Frequency Band