User guide

1424-EN/LZT 103 089 A3 2012-02-23
User Manual
Cordless Phones for MX-ONE™
84
LED Error Indications
See also chapter LED Indications during Easy Replacement on page 80.
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third handset, that is another handset than the "old" (the replaced handset) and "new" (the
replacement handset) handset, is inserted into the charger during Easy Replacement, this error
indication appears. Change to the correct handset.
2) The charger has found that Easy Replacement does not work. Change back to the "new"
handset.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both handsets need to be sent for service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
SERVICE NEEDED
Parameters corrupt.
Note: This display
message is only shown
in English.
The handset is defective. Select reset option on the middle
soft key if available or if no reset
option is available or fault does
not resolve the handset needs
repair. Note: Display message
only shown in English.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
PDM or do a factory reset via
PDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault persists
do a factory reset via admin
menu or PDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
PDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the handset
in combination with;
1) Unencrypted base station(s); and/
or,
2) Unsupported base station(s).
1) Disable the "Encryption
required" parameter in handset
via PDM; and/or,
2) Enable the encryption in the
base station(s); and/or,
3) Use supported base station(s).
Ask your supplier.
Not allowed 2) The extension (User) does not
exists.
3) The password is not correct.
2) Make sure that you entered
correct extension. If needed,
contact the system administrator.
3) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.