User guide

1424-EN/LZT 103 089 A3 2012-02-23

User Manual

Cordless Phones for MX-ONE™

7 Alarm Operation

The parameters described in this chapter are set in the WinPDM/CPDM3. See the handset’s

Configuration Manual.

Note: The alarm functionality is applicable for DT423/DT433 only.

7.1 Push-Button Alarm

The push-button can be defined to send an alarm by a long press and by multiple press.

By default, long press is defined for test alarm (see 7.1.1 Test Alarm), and multiple press is

defined for personal alarm (see 7.1.2 Personal Alarm).

7.1.1 Test Alarm

Press and hold the push-button until a dialog window "Test Alarm" (default) is

displayed. Depending on set parameters;

• a beep is heard

• the orange LED flashes twice

• the vibrator stirs

• the handset receives a notification that the alarm has been received by the system. This is a

system dependent feature.

• if configured, the ALS (see 7.5 Acoustic Location Signal on page 38) is activated after the

alarm has been sent, or a call is established to a pre-defined number (see 7.6 Automatic Call

after Alarm on page 39)

• information about the handset’s location is sent along with the alarm, see 7.3 Alarm with

Location Information on page 38.

7.1.2 Personal Alarm

Press the push-button twice or more, the dialog window "Personal Alarm" (default) is

displayed. Depending on set parameters;

• a beep is heard

• the orange LED flashes twice

• the vibrator stirs

• the handset receives a notification that the alarm has been received by the system. This is a

system dependent feature.

• if configured, the ALS (see 7.5 Acoustic Location Signal on page 38) is activated after the

alarm has been sent, or a call is established to a pre-defined number (see 7.6 Automatic Call

after Alarm on page 39)

• information about the handset’s location is sent along with an alarm, see 7.3 Alarm with

Location Information on page 38.

7.2 Man-Down and No-Movement Alarm

Man-down alarm: If the handset is tilted 45 degrees

or more for a preset time (default 7

seconds), the Man-down alarm will be triggered.

No-movement alarm: If no movement is detected during a preset time (default 30 seconds), the

No-movement alarm will be triggered.

6.The accuracy is -/+10 degrees.