User guide
1424-EN/LZT 103 089 A3 2012-02-23
User Manual
Cordless Phones for MX-ONE™
30
6 Calling
6.1 Incoming Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset, gives a notice of a
call. Ring signal and vibrator can be disabled, see 8.8.1 Sound and Alert Settings on page 61.
The calling party’s handset number or name is shown. The name will be shown if the calling
party’s handset number is stored in the local phonebook.
6.1.1 Answer a Call
When the signal sounds, press to answer the call, or press to answer the call in
loudspeaking mode
1
. The name/number of the calling party is displayed if calling line
information is available.
Tip: When a headset is connected to the handset, the headset button can be used to answer the
call. In addition, it is possible to configure the headset button with a specific function, such as
post-dial, dial last called number, or dial a predefined number. See the handset’s Configuration
Manual.
Other answering methods can also be set in the Settings menu, see 8.8 Settings on page 61. The
answering methods are; Automatically and Loudspeaking.
When Automatically is enabled, all incoming calls will be connected automatically.
Call Pick-Up
To answer a call to a phone in another room
1 Dial the number and press
2 When you hear a busy tone, Press 8 (France and New Zealand: Press 4 Sweden: Press 6)
6.1.2 End a Call
A press on ends the call. The duration of the call is shown in the display. The total time of the
call can also be retrieved from the Calls menu > Call time.
6.2 Outgoing Call
6.2.1 Pre-Dial
Enter the number and press to get the line. The number is shown on the display while
dialling. If needed, press "Clear" to erase the number. By using the navigation key it is possible
to step and add/delete a digit in a number.
It is possible to turn on the tone sender in a pre-dialled number by long pressing .
6.2.2 Post-Dial with Headset Button
If a headset is used, it is possible to press its button
2
to get a ring tone and then enter the number
to be dialled.
1.When Bluetooth is enabled, the loudspeaker audio is lowered due to current limitations in the intrinsically safe handset.