User guide

21Dialog 4422 IP Office

Start the Phone — Log On/Off

LAN access control (network authentication)

(Dialog 4422 v. 2 phone only).

Your telephone might require a network authent

ication to gain

access to the network. In this case you must enter a valid user

identity and PIN or password.

Note: The user identity and password use

d for the network

authentication is not the same user identity and password

you use to log on. The password is obtained from, and can

only be changed by the system administrator.

LAN access control

Enter user ID:

z Enter your user identity.

(The Minus key is used to remove a wrong entry.)

Press.

z Enter your PIN or password.

(The Minus key is used to remove a wrong entry.)

Note:

The password can be entered with letters or numbers, see

section “Entering le

tters and numbers” on page 27.

The PIN is the same as the Individual Authorizat

ion Code.

Only digits can be used as PIN. The PIN must be four digits

or more.

Press.

If your user identity and passwor

d are accepted, the phone

continues with the startup procedure.

Note: If your user identity and password are not accepted,

ntact your system administrator.