Specifications

Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 359
6.3.6.1 Adding EIP cards for AXD configuration
6.3.6.1.1 Simplex AXD configuration
CONTRAINTE
• This configuration implies stopping the system.
• The configuration data needs to be changed if the system is expanded. Before adding
new components, first back up the data.
• Immediately after installing and programming any new components, you should make
a second backup, to save the system's new configuration.
Procedure
• Back up the configuration.
• Power off the iPBX.
• Remove the UCV card on which you will be installing the daughter card.
• Install the EIP cards on the appropriate connectors. Installing a daughter card on a
card requires the use of spacers. The daughter cards are screwed onto the cards.
• Re-insert the UCV card fitted with EIP cards.
• Power on the system (expansion cabinets first then the main cabinet).
See Aastra Management Portal operating manual for the different phases.
• Declare the network parameters of the EIP cards.
Nota : The internal IP address of the IP cards must be declared on the same sub-
network as that of the CPU card.
• Activate the EIP cards.
• Check the status of the EIP indicators on the front panel (see Sections 4.3 to 4.14).
• Connect the EIP cards to the network.
• Save the configuration.