Specifications

AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 356 01/2011 Installation and activation
6.3.5 Adding a daughter card on an expansion card (AXD, AXL, AXS, AXS12 and
AXS6)
Adding a daughter card increases the capacity of an expansion card.
CONTRAINTE
• The configuration data needs to be changed if the system is expanded. Before adding
new components, first back up the data.
• Immediately after installing and programming any new components, you should make
a second backup, to save the system's new configuration.
Procedure
Important : Before removing the card to be equipped from the cabinet, check that it is hot-
unpluggable. See Section 6.3.2.
• Remove the card on which you will be installing the daughter card.
Depending on the CLX card or equipment type, see Section 6.3.2 for the operation.
• Install the daughter card(s) on the appropriate connectors. Installing a daughter card
on a card may require using spacers. Daughter cards are usually screwed onto the
cards.
• Check the configuration of the card to be equipped. If required, change the position of
the micro-switches according to the new configuration of the card (see Sections 4.14).
• Depending on the type of card, follow the installation procedure described in Section
6.3.2.