Installation manual

IM2803MG.DOC., DIR. 912802 IM2803 Shadin Avionics

INSTALLATION MANUAL

IGIDATA

Rev: M

P/N 912802-A, 912802-03A, 912802-03A-G

Page: 7-1

7.0 INITIALIZATION

1. The DigiData is preprogrammed (Initialized) prior to shipping. If changes are required in the

DigiData setup, use Drawing 4028-716 to create a configuration harness (“Loop-Back”

harness). Refer to the Operating Manual P/N OM2802 and the Tables listed in section 9 of

this manual for programming instructions. Before making changes it is advisable to record the

current settings.

2. Refer to the Navigational Receiver manual for serial port setup. It is necessary to have both

the DigiData and the Receiver configured correctly.

3. If you need to change the K-factor and or Offset for P/N (s) 912802-03A or 912802-03A-G

refer to the “DigiData Analog Fuel Flow Chart” Table 1 contained in Section 9.1.