Installation manual

IM2803MG.DOC., DIR. 912802 IM2803 Shadin Avionics
INSTALLATION MANUAL
D
IGIDATA
Rev: M
P/N 912802-A, 912802-03A, 912802-03A-G
Page: 5-5
5.7 Connection to the Pitot and Static Lines
The pitot static line should be cut and a tee is installed to tap into these lines. Use the appropriate
type of fittings to match the type installed in the aircraft. Use approved practices when installing
these lines and perform a leak check before returning the aircraft to service.
PITOT/STATIC adapter helpful hints
To make an adapter for the Shadin DigiData, the following parts could be used. It is recommended to use all
aluminum fittings.
Existing Pitot/Static lines AN910-1D AN816-2D #2 Hose(with female fittings)
AN910 DASH NUMBER PIPE AN816 DASH NUMBER TUBE PIPE
BRASS ALUM. ALLOY SIZE STEEL ALUM. ALLOY O. D. THREAD
-1 -1D 1/8” -2 -2D 1/8” 1/8”
-2 -2D 1/4” -3 -3D 3/16” 1/8”
-3 -3D 3/8” -4 -4D 1/4” 1/8”
-4 -4D 1/2” -5 -5D 5/16” 1/8”
-6 -6D 3/4” -6 -6D 3/8” 1/4”
-8 -8D 1” -8 -8D 1/2” 3/8”
-10 -10D 5/8” 1/2”
-12 -12D 3/4” 3/4”
-16 -16D 1” 1”
MS20825 TEE TUBE PIPE
STEEL ALUM. ALLOY O. D. THREAD
-2 -2D 1/8” 1/8”
-3 -3D 3/16” 1/8”
-4 -4D 1/4” 1/8”
-5 -5D 5/16” 1/8”
HOSE: Stratoflex 193-2 or Aeroquip 306-2 with MS27404 (P/N 311-2D) on each end.
Air source
MS20825 Tee
AN910
AN816 DigiData
MS27404