User`s guide

Personalizing your phone
eud-1290/1.0 – R1.0 – 01.2011 67
Activating range alarm and system busy beep
You want to set the system parameters with your cordless phone.
The Range alarm indicates that the connection between your phone and the system is
weak. You can set the phone so that you receive a warning signal if you leave the cov-
erage area
You are making a call and are getting near the limit of the radio area: A warning signal
sounds in the loudspeaker and the LED indicator is flashing red. If you leave the radio
area, the call is disconnected.
The System busy beep tells you that the system is overloaded – you need to wait until
the system is available again.
Setting the server alarm
Depending on the system’s settings, you can receive server alarms for specific situa-
tions. These settings are made by your system administrator in the system. Contact
your system administrator for more information.
When the server alarms are activated in the system, you can select from the alarm sig-
nalling as follows: Vibracall, Progressive ring tone, Suppress ring tone.
A list of all melodies is available.
Press the navigation key to the right or the Menu softkey.
Settings
Scroll to Settings and press the Select softkey.
General
Scroll to General and press the Select softkey.
<Setting>
Select the setting you want and switch on or off with the Select softkey.
Note:
Your settings for Vibra call and Suppress ring tone can be overruled by the alarm
server.