User guide

Chapter 10, Multi-Ring
110 Aastra – 2736-007
Example:
Multi-Ring
Line 25008………………OFF
Line 25010………………OFF
Line 5587…………………ON
On
Done
Off
Figure 4 Multi-Ring on Multiple Lines Display
Remote Access
Multi-Ring Remote Access is an added feature of Multi-Ring that allows you to remotely
change the Multi-Ring enable/disable status of lines on Pointspan. You can be another
Pointspan station user or an off-switch user dialing into Pointspan (via a trunk to
Pointspan).
Multi-Ring remote access is initiated as follows:
 A remote user dials a feature directory number set up with the new Multi-Ring
Remote Access.
 A remote user dials a numeric feature code set up with the new Multi-Ring Remote
Access.
 The Personal Id (PIN) assigned to a Voice Line provides security for that line so
unauthorized users cannot change the Multi-Ring status.
Your system administrator will provide these tools for Remote Access.
Using Remote Access
To access Pointspan, you can either dial a DID number defined as Multi-Ring access that
contains the feature directory number, or dial into Pointspan over an incoming dialed
trunk and then enter the feature directory number or numeric feature code.
Note:
Prompts are given by tone only.
Step
Action
Result
1.
Dial into Pointspan using one of the
two methods:
 A feature number defined as Multi-
Ring Remote Access.
Or
 The numeric feature code defined
as Multi-Ring Remote Access.
You hear a ZIP tone that prompts for
the directory number of the line to be
accessed.