System information

FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
Examples
Page 2-50 Proprietary Information Aastra
Alternatively to this solution, a conference can also be configured in node 2.
Here only the converters and no interfaces of the module will be involved in
the conference. In this case, converters 1 and 2 are also connected to the
corresponding ports for main line routing. Channel 14 (subscr. A-4) is
applied to a free converter.
Example of a 2 x 4-subscriber and 8-subscriber conference
The example depicted below shows two independent conferences, i.e.
conference A and conference B. For this application, the modules used
must be adjusted for both the 8-subscriber and 2x4-subscriber conference.
Figure 2.27: Example of an 8-subscriber and 2 x 4-subscriber conference
Conference A subscribers:
• Conference subscriber A-1
• Conference subscriber A-2
• Conference subscriber A-3
• Conference subscriber A-4
• Conference subscriber A-5
• Conference subscriber A-6
Main line - Conference A
The main line of conference A starts in node 1 and is routed in
channel 10 [A] via nodes 2, 3 and 5 to node 6. Along this main line,
subscribers A-1, A-3, A-4, A-5 and A-6 are connected. Subscriber A-2 is
connected to the conference via a sub-line (see below).
FlexPlex XMP1
Conf. subscr. A-1
Node 1:
FlexPlex XMP1
Node 2:
FlexPlex XMP1
Conf. subscr. A-3
Node 3
FlexPlex XMP1
Conf. subscr. A-2
Node 4
FlexPlex XMP1
Conf. subscr.
A-4
Node 5
FlexPlex XMP1
Conf. subscr. A-6
Node 6
C
hannel 10[A]
Channel 10 [A]
Channel 10 [A]
Channel 11 [A]
Channel 11 [A]
Channel 10 [A]
Central
station
Conf. subscr.B-1
Conf. subscr. B-2
Conf. subscr.B-3
Conf. subscr.A-5 Conf. subscr.B-4
Module with 8-subscr. EDC
Module with 8-subscr. EDC
Module with 2 x 4-subscr. EDC
Module with 2 x 4-subscr. EDC
Channel 20 [B]
Channel 20 [B]
Channel 20 [B]
Channel 20 [B]
Module with 2 x 4-subscr. EDC
Channel 20 [B]