System information

FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
ISDN Channel Modules
Page 9-28 Proprietary Information Aastra
Table 9.K: ISDN channel modules
9.10 ISDN Channel Modules
9.10.1 ISDN S0F
The ISDN S0F modules (with remote power supply) are used for setting up duplex point-to-point
connections between ISDN PBXs via XMP1 or as subscriber extension of a PBX.
Bit rate 192 kbit/s
Interface 4-wire, capable for bus operation
Impedance 100

Number of interfaces on the module 4
9.10.2 ISDN UQF (4) UK0(Q)
The transmission procedure used is the standardized ISDN echo cancellation procedure.
The 2B1Q code with remote power supply is available.
Using the ISDN UK0Q module, it is possible to set up a UK0-UK0 or Uk0-S0 connection between
private branch exchanges (PABX-PABX) via XMP1 systems. Two UK0 interfaces interconnected
via the XMP1 system ensure the information exchange between e.g. 2 NTBAs or 2 PABXs required
for this purpose.
Code 2B1Q
Baud rate 80 kBauds
Impedance 135 Ohms
Interface 2-wire, echo compensation
Remote power supply optional
Number of interfaces on the module 4
9.11 Signal Concentrator
9.11.1 Power supply
Supply voltages +7 V, +5.1 V - premating
DC/DC converter input voltages
± UB 35 to 75 V
Converter input voltage
± UB
12V or 24V
+ or - pole tied to ground, switchable
9.11.2 Equipment safety
Requirements EN 60 950
9.11.3 EMC
EMC requirements EN 300 386
Radio interference DIN EN 5022
Immunity to EMC interference DIN EN 50 024
EMC railway systems EN 50 121-4