System information

FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
XMP1-SL
Aastra Proprietary Information Page 8-25
8.8 XMP1-SL
The XMP1-SL (05HAN00499AAC) is composed of a 19“ housing with the
following dimensions:
Width: 450 mm
Height: 55 mm
Depth: 300 mm.
The XMP1-SL can be mounted in 19“ and ETSI racks. The unit is equipped
with special mounting flanges appropriate for installation in both rack types.
The XMP1-SL cable connections are set up via connectors located on the
front side of the unit.
The XMP1-SL offers a card slot which can be equipped with a XMP1
module. This card slot is accessible from the front and closed by means of
a cover plate. The connecting cables of the module are routed to the outside
via openings on the right-hand side of the cover.
Two further positions located on the main board can be equipped with DSK
Modular cards. These cards are connected via X21 and X22 on the front
side of the XMP1-SL unit. Assignment between mounting positions and
connectors:
• Connector X21 -> lower mounting position
• Connector X22 -> upper mounting position
The seizure of thes connectors depends on the module mounted.
For grounding the XMP1-SL there is a grounding bolt on the left side of the
equipment unit.
The supply voltage range of XMP1-SL can be set to 24 V DC or
48/60 V DC. The switch for adjusting this supply voltage range is accessible
through a small opening on the left side of the unit.
The PSU-XMP1-SL power supply is mounted in the left-hand section of the
main board.
For more detailed information please refer to the Description and Operating
Instruction XMP1-SL (05PHA00363AAU).