System information

FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
Configuration Using the SOX MSP
Aastra Proprietary Information Page 7-11
7.2 Configuration Using the SOX MSP
7.2.1 General
The SOX MSP is a windows-based software which has been specially
developed for the configuration and operation of the XMP1 node.
The Service PC requires the LMT Operator Terminal XMP1 for SOX MSP
(V5.1) and SOX MSP Software.
The Service PC is connected to the XMP1 node. The LMT software is
started and a connection to the network is set up via the network view. The
network view permits the XMP1 nodes integrated in the QD2 infrastructure
to be addressed.
The connection can be set up serially or via TCP/IP. After the successful
connection setup, an MSP and possibly a XQI2 appears underneath the
SISA-0. The SOX software is started up by activating the XMP1 application.
The SOX MSP application can also be used for the offline configuration of
the XMP1 node without a direct connection to the latter.
7.2.2 Functional units of the SOX MSP software
The SOX MSP software supports the complete configuration of a node on
the one hand, while all operating functions supported by the XMP1 node
can be executed on the other.
Functions
• Complete node configuration, i.e. equipment with modules
• Support of all previous XMP1 modules
• Complete configuration of all modules
• Configuration of all connection types possible
• Configuration of CC8 connections most frequently used
• Configuration of clock priorities
• Support of the following online functions (operator functions):
— Node status request
— Firmware status request
— Co-channel radio alignment
— Loopback switching
— Line test
— Debugging
— Request of remote inventory data
— Setting node passwords
— Display of signal concentrator statuses and controlling outputs
• Readout of configuration data from the node and file
• Saving configuration data in the node and to file
• Reports for alarms, configuration