System information

FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
IP settings for the Ethernet adapter/CU-E
Aastra Proprietary Information Page 6-39
Menu item 72: Enter Subnet Mask
Using the subnet mask option, you can mask part of the IP address (Internet
Protocol address). This leads to a splitup of the IP address into the network
and host portion.
Example: 255.255.0.0
Menu item 73: Enter DNS Address
The IP address of the Domain Name Server (DNS) is entered via menu item
73. The DNS performs a translation between the host name and IP address.
Menu item 74: Enter Address Source Mode
BootP always
The NE gets the IP configuration data exclusively from a BootP/DHCP
Server. If no BootP/DHCP Server is addressable, IP operation is not
possible.
BootP + Fallback
The NE gets the IP configuration data from a BootP/DHCP Server. If the
BootP/DHCP Server is not addressable, the data stored in the NE are used.
BootP + Fallback + Update
The NE gets the IP configuration data from a BootP/DHCP Server. If the
BootP/DHCP Server is not addressable, the data stored in the NE are used.
Once the BootP/DHCP Server can be addressed again, the data provided
by the latter are used. The memory in the NE is overwritten by these data.
Static values
IP settings are manually entered via menu items 70-73 of LSP/WINLSP.
Menue item 79: Activate the IP settings
Via menu item 79, you can activate the IP settings.
Note: In case of a Central Unit equipped with a CUE sub-board,
the IP settings must be taken over by means of a reset, e.g. by
extracting and reinserting the Central Unit or by entering the
"reset p" debugging command.