Manualshelf

System information

ManualsBrandsAastra ManualsComputer equipment675 XI
919293949596979899100
FCD 901 48
Issue R2A, 07.2009
XMP1 Release 5.5 System Description
Configuration
Page 2-54 Proprietary Information Aastra
In order to permit "ripping up" meshes, a tree must still be set up starting
from a root. However, this tree is independent of traffic signal transmission.
Info no. 23 set to "1".
Info no. 24: Exp. Dig. conf: Root depends on C/RTS yes=1
For special cases of application, it is possible to configure several roots, i.e.
Masters. Using this card slot information, you can define that one of the
Masters configured can declare itself as Master by activating a control line.
Note: This option is not applicable to G.703 or WT modules,
since control lines are not available.
Decentral card slot data
Info no. 14: Preferred path for conference
Using this info no., you can define the interface or converter located in the
preferred conference path. This path will then be preferred as return
direction to the root (Master). The alternativ path is used if the preferred path
is not available. If the fault in the preferred path is resolved this path will be
used again.
Info nos. 27 to 29: Sync.Freq.| EDK
Info nos. 27 to 29 can assume two different meanings:
1. With an EDC active on the module (setting via central card slot info
no. 21:
= 1, the settings are applicable to the Expanded Digital Conference.
2. With info no. 21: Central =0, the previous meaning "Info no. 21:
Frequency table" will apply.
Info no. 27: Sync.Freq.| EDK: conv. takes part yes=1
The converter of the sub-address will be involved in the conference.
Info no. 28: Sync.Freq.| EDK: intf. takes part yes=1
The interface of the sub-address will be involved in the conference.
Info no. 29: Sync.Freq.| EDK: intf. root poss. yes=1
Using this info no., you can define the subscriber unit connected to the interface as
Master.
Tab. 2.L: Decentral card slot data for EDC
Info no. Designation
14 Preferred path for conference yes=1
27 Sync. Freq.|EDK: conv. takes part yes=1
28 Sync. Freq.|EDK: Intf. takes part yes=1
29 Sync. Freq.|EDK: intf. root poss. yes=1