Specifications

PA-001011-03-04 Aastra July 2014
189
Syntax:
Melody.Stop:
Example:
<ExecuteItem URI="Melody.Stop:"/>
4.7.2 File format
The phones support only the following file format:
 Wav file
 G.711 µ-law and a-law Codec
 20 ms packet size
 Mono 8KHz
 200 kb
If the format is not supported by the phone, the request is declined.
4.8 Dial and DialLine URIs
The phone supports 2 URI commands to launch an outgoing call from XML.
 Dial:XXXXX
 DialLine:Y:XXXXX
Where XXXXX is the number/URI to dial and Y is the SIP line number.
Note: The AastraIPPhoneDirectory object does not support the “Dial” and “DialLine”
commands.
The difference between Dial and DialLine is that with the DialLine command you can specify which
SIP line to use, Dial will use the first available SIP line on the phone.
Dial and DialLine are generic URI and can be used anywhere a URI is requested by an XML
object, this can be a custom softkey, an item in a TextMenu.
Although the line range is defined as 1 to 9, you must have a SIP account configured on the line to
use the dial tag.
For example, if you configure lines 1 to 4 on a phone using a line value of 5 results in undefined
behavior. The range of lines you can use for values is limited to the number of lines that the phone
supports.
The following table identifies the number of lines supported on each phone type.