Installation guide

26/1531-ANF 901 14 Uen E10 2014-01-22 59
C
ONFIGURING THE PHONE
11.26 Selection of Transport Addresses (Port
Numbers)
The table below shows the default port numbers. The ports are possible
to change via the aastra.cfg file. For more information, see Adminis-
trator Guide for Aastra Models 6700i and 9000i Series IP SIP Phones.
Table 6 UDP/TCP default ports used by the phone
11.27 Registration Distribution
When the registration distribution feature is enabled in the system, the
Aastra 6700i phones will be configured to register in the server with the
generic extension data.
In the MX-ONE concept called HLR (Home Location Register) server,
the configuration is a part of the initial REGISTER procedure. The
phones will as the main rule be registered in their home server, but if the
Type of
signalling Minimum Maximum Comment
RTP 3000 The first media stream,
uses 3000. The second
mediastream uses 3002
and so on.
RTCP 3000+1 RTP port + 1
SIP 5060 5060
SIP secure
port
5061 5061 When using the phone in
SIP / TLS mode.
MX-ONE
Aastra XML
API port
22222 22222 Used in combination
with http:// when
configuring /Logon and
/Startup
MX-ONE
Aastra XML
API secure
port
22223 22223 Used in combination
with https:// when
configuring /Logon and
/Startup
Configuration
Server HTTP
80 80 when downloading
configuration and
firmware files
Configuration
Server HTTPS
443 443 when downloading
configuration and
firmware files