Installation guide

26/1531-ANF 901 14 Uen E10 2014-01-22 53
C
ONFIGURING THE PHONE
With this setting the # character will be sent to the PBX in a correct way,
even in the middle of a procedure for example *42#B-number#.
11.16 Authentication code shall not be visible
When entering a service code procedure containing an authorization and
PIN code, it is possible to prevent the authorization or PIN code to be
stored in the logs. The configuration for this is done in the aastra.cfg file.
There are two options:
• All the entered digits after the service code are replaced. Example:
the user enters *72*99999# where 99999 is the authorization code,
*72******# will be shown in the display and in the re-dial list.
• The procedure contains service code + authentication code +
number. In this case the function code and number will be shown in
as they are entered and the authentication code will be replaced by
stars. Example: the user enters *75*99999*6709# where 99999 is
the authorization code and 6709 an extension number,
*75*******6709# will be shown in the display and in the re-dial list.
The syntax to be used in the aastra.cfg file is shown in following
example:
pin suppression dial plan: *72*(X+)# | *75*(X+)*X+#
This setting will give the result shown in the example above.
11.17 Free on Second Line
If the telephone shall be able to receive calls on another line although
there is a call on line 1 already, Call Waiting must be enabled.
Use the web UI:
Global SIP Settings > Basic SIP Authentication Settings.
Call Waiting is also set per line and this setting overrides the global
setting.
The default value is Call Waiting = Enabled.
If the telephone shall send busy when a new call arrives and there is an
ongoing call on the first line, Call Waiting shall be set to Disabled.