Installation guide

AASTRA 6700I SIP TERMINALS FOR MX-ONE
30 26/1531-ANF 901 14 Uen E10 2014-01-22
11 Configuring the Phone
This chapter describes how to configure the phone from the phone
menus as an administrator.
This chapter also covers the configuration via the configuration files,
aastra.cfg, <model>.cfg or <mac>.cfg.
The parameters can be set in any of these configuration files, but in this
section it is the recommended placing that is described. If one parameter
occurs in several configuration files, it is always the last read parameter
value that the telephone uses.
11.1 Settings mode
To enter into settings mode in the phone user interface:
• Press (Options key)
To enter the web user interface:
• Find the IP address of the telephone by selecting Options > Phone
Status > IP & MAC Addresses
• Enter the IP address to the telephone into the address field in the
web browser in the PC and press enter.
• To log in to the end user page, see 12.2 Web Interface Passwords
for End Users on page 63
• To log in to administrator page, see 10 Entering Administrator
Mode on page 29.
11.2 Settings in the configuration file aastra.cfg
The necessary settings in the configuration file for getting the telephones
to work in a correct way with MX-ONE are created automatically when
using MTS. In the configuration file aastra.cfg the parameters must
have the following values:
! sip aastra id: 1
! sip send line: 1
! sip xml notify event: 1
! sip pai: 1
! directed call pickup: 1