Installation guide

26/1531-ANF 901 14 Uen E10 2014-01-22 23
H
OW TO START A NEW PHONE
The terminal can be logged of via command extension_unregistration
--forced. Then it will prompt for logon after the reboot:
Write protect the logoff keyset.
Example: Change the logoff key to be a speedial to call the operator and
write protect it by prefixing with “!”.
!softkey9 type:speeddial
!softkey9 label:Operator
!softkey9 value:09
The Diversion key kan also be write protected in the similar way.
As the ‘action uri startup’ is used Free Seating is enabled, which means
that the terminal may be pushed out
Alternative2. Use the MAC file to explicitly set an extension number:
sip line1 user name:<extension number>
sip line1 password:<PIN code>
If the PIN code is changed in MX-ONE, it must also be manually
changed in the <mac>.cfg file.
Inactivate action uri startup (set in aastra.cfg) by setting it to an empty
string (this will also inactivate Free Seating. The terminal will not be
pushed out when someone logs in using the same extension number on
another phone):
action uri startup:””
With logon at startup disabled, SIP registrar must be set in the <mac>
file to trigger the phone to register. ( aastra.cfg setting is 0.0.0.0 ):
sip proxy ip: <mx-one ip address/host>
sip registrar ip: <mx-one ip address/host>
Change and write protect the logon/logoff key as described earlier.
7.5 Message Waiting Indicator
The red lamp in the upper right corner is called message waiting
indicator and is used in the following cases:
• message waiting indication: blinking slow
• incoming call: blinking fast
• no service: lit.