Operation Manual

Basic Functions

Other alarm parameter settings

Alarm number: If the SOS emergency call number is predefined by the system, this

menu entry does not appear.

OpenCom 100 / Aastra 800 systems only: Always save the SOS emergency

call number with the prefixed R-key function (enquiry/hold). Then an emer-

gency call can also be made during a call (depending on mobile unit – see

above). Press the hash key 3 times to enter the R key function.

Other systems: The “Hold” function may be generated using other codes on

other systems. The respective system documentation provides information on

suitable programming.

If there is no alarm number saved, the SOS emergency call number – if there is

one – is called alternatively.

Alarm auto answer: If the function is activated, any call is automatically accepted

during Pre call. If the function is deactivated and there is an incoming call

during pre-alarm, or a call already being made, the alarm call number is dialled

after pre-alarm.

No matter what the setting, calls from the alarm call number or the SOS emer-

gency call number are automatically accepted and pre-alarm ended.

Alarm tone: Pre-alarm can take place with/without an alarm tone on the mobile unit.

When the alarm tone is activated, it is signalled with increasing volume.

Repeat alarm: This is the time interval after which another pre-alarm including sub-

sequent dialling of the alarm call number is executed (e.g. because calling the

alarm call number was cancelled by the system).

Handsfree in alarm: You can configure whether an alarm call is done in handsfree or

receiver operation. This setting also applies to the emergency call via the SOS

emergency call key.

Event

Mandown, No movement, Escape

detected

Delay Pre alarm

with/without alarm

tone on the mobile unit

Dialling of the

alarm call number