User`s guide

Supplementary features
62 eud-1281/1.0 – R1.0 – 12.2010
Activating ring alone
You want to specify which of your phones shall ring acoustically when you receive a call.
When your system administrator has set up a phone number with several phones, you
can define on which phones a call shall acoustically be signalled using ring alone.
When you have activated ring alone on a phone, the acoustic ringing tone is deacti-
vated for all other phones ( ). An incoming call is signalled in the display of all
phones. You can answer the call on each of your phones.
This function must be stored under a Foxkey or a function key (see Chapter "Configu-
ring keys", page 86).
Silent intrusion
Silent intrusion is a variant of the Intrusion function and is used mainly in call centres.
Another user can intrude on your active call and listen in to your conversation without
you and your call party noticing. Unlike Intrusion you will receive neither a visual nor
an acoustic signal.
This means you cannot reject Silent intrusion. The third user's microphone remains
switched off. He can however intrude on the call at any time by enabling his micro-
phone or pressing the Intrusion function key.
Note:
When you have activated ring alone but deactivated the personal call routing for a phone in parallel, an
incoming call is not acoustically but only visually signalled.
In the idle state:
Press the function key for <Ring alone>.
➔Ring alone is activated/deactivated.