User guide

it rests on the stand. Connect the phone cord to a

phone jack and plug the power adapter into a power

outlet.

6. Install the phone on a wall

A. Connect the cord to the wall jack.

‡

B. Coil the phone cord into the space provided on the

back of the phone.

C. Align the telephone so the hooks on the wall plate,

align with the wall-mount slots on the back of the

phone, as shown here.

D. Push the phone onto the pegs, and then slide it

down until it is secure

E. Plug the power adaptor into a power outlet

Sayson 390/480e P

hones for TeleVantage

Installation

3. Connect the cords

If you attached the stand to install the phone on a

desk, route both the phone cord and power adapter

cord through the opening in the stand. Insert the

phone cord into the slot on the back of the telephone

marked until it clicks into place. Insert the power

cord into the power jack marked .

Note: You should connect the power adaptor to a surge

protector or power bar.

4. Press the cords into grooves

Press the cords into two of the grooves provided on

the bottom the stand. This will allow the stand to sit

flat on a desk surface.

5. Install the phone

If you have installed the stand and are using the

phone on a desk—simply turn the telephone over so

Sayson 390/480e P

hones for TeleVantage

‡

Note: You may wish to purchase a short phone cord from a

local supplier for a wall installation.