User guide

Installation

The mobile unit begins checking in and displays Searching for a DECT System.

This procedure should be completed very quickly. If the entries are not correct or

the radio connection is inadequate, a progress bar appears on the mobile unit. In

this case, cancel the procedure using the

Esc

softkey and repeat the subscription

with corrected entries.

Note

When you prefix authentication code entry with the star key, the mobile unit will

be checked in as a GAP device.

Tip: The length and quality of the authentication code used

depends on your security requirements. Please keep in mind

that the memory required for the authentication code

increases 4 bits per additional digit.

After checking in successfully, you can enter name and number for the new sub-

scription entry. Confirm with the

softkey.

Note

If you wish to subscribe the mobile unit to a GAP base station for instance, the

process is often started with a simplified procedure. In many cases, press a key on

the GAP base station to open a subscription time frame. During the time frame,

start the simplified subscription and confirm all requirements on the mobile unit

with the

softkey.

Z Enter Auth.Code: now enter the maximum 8-digit code that you

entered into the communications system Configurator.

Press softkey to confirm and continue.