Operation Manual

5.3 The FX View 35
0 dB
Amp
Frequencyf0
2xf0 3xf0 4xf0 5xf0 6xf0
Light effect (mix=0.1)
Medium effect (mix=0.25)
Strong effect (mix=0.5)
Figure 16: Effect of the mix between wet and dry signal on the frequency response of a Flanger
module
0 dB
Amp
Frequencyf0
2xf0 3xf0 4xf0 5xf0 6xf0
Feedback = 0.9
No Feedback
Feedback = 0.5
Figure 17: Effect of the amount of feedback on the frequency response of a Flanger module.
Tuning
The delay length, in milliseconds, is adjusted with the Delay knob. The length of this delay can be
modulated by a certain amount depending on the adjustment of the Depth knob. In the left position,
there is no modulation and the length of the delay line remains constant. As the knob is turned to
the right, the length of the delay line starts to oscillate by an amount which increases as the knob is
turned clockwise and at a frequency fixed with the Rate knob. The Feedback knob is a gain knob
used to fix the ratio of wet signal re-injected into the delay. Finally, the Mix knob determines the
amount of dry and wet signal in the output signal from the module. When this knob is adjusted in
its leftmost position, only dry signal is sent to the output, in its center position, there is an equal
amount of dry and wet signal in the output signal while in its rightmost position, only wet signal is
sent to the output. Note that the Depth parameter is also adjustable from the Play view.