Installation manual

COMPONENT REPLACEMENT
Step 1 Ensure the fire is cold. Turn off the gas
supply at the gas service cock.
Step 2 Remove the coals.
Step 3 Remove the rear matrix plate, undo the
three retaining nuts.
Step 4 Remove the control valve heat shield.
Undo the two retaining screws located
on the left-hand side of the shield.
Slide the heat shield backwards and lift out
carefully. Do not damage the covering.
Step 5 Disconnect the gas supply pipe at inlet
to fire.
Step 6 Remove the gas control knob (pull off)
and remove the M15 control valve
retaining nut (17mm spanner).
Step 7 To remove the burner bracket, burner and
control valve assembly, undo the two
retaining screws located on the front ledge
of the appliance.
After component replacement, ensure that a
check on the gas tightness of any new joint is
made by using a soap/water solution.
REPLACEMENT OF THE DOOR
SEAL
Step 1 Remove the door, by opening the door and
gently tapping the door upwards, this will
lift the door off of its hinges.
Step 2 Remove the old door seal and old
adhesive, using a wire brush ensuring that
the surface is clean and dust free.
Reference the Bunny- Record the pattern
of the sealing strips.
Step 3 Apply the new adhesive to the door
casting.
Step 4a Becton 7. Starting at one end press the
new door seal into the adhesive, continue
around the door, making sure that the two
ends of the seal are touching. Cut off any
excess seal.
Step 4b Becton Bunny. Relay new sealing strips as
recorded pattern.
Step 5 Allow the adhesive time to cure
(approximately 2 hours depending on the
adhesive).
Step 6 Carefully refit the door and close.
REGULAR SERVICE
See "SAFETY NOTICES" ref coal set page 4.
Any soot or debris should be removed from the
fuel bed regularly by the user.
Step 1 Isolate the gas supply to the fire using
the gas cock supplied at installation.
Step 2 With the appliance cold, open the main
door by turning the handle through 180°
degrees.
Step 3 Carefully remove and clean the fuel effect
coals of any soot deposits with a soft
brush.
Step 4 Remove any soot deposits from inside
the fire using a vacuum cleaner.
(See not under ‘Coal set’ on page 4)
Step 5 Replace the coal set as described in
"Arranging The Coals" on page 7.
Becton Bunny & Becton 7 MK2 Gas stoves 19
SERVICING