Instruction Manual

ARROWHEAD ALARM PRODUCTS Ltd.
344b Rosedale Rd,
Albany, Auckland.
Ph. 09 414 0085
www.aap.co.nz
v1.00
Pairing AJ-718 Heat Detectors with Wireless I nterconnect
Step 3.
Select a Master
Press & hold the test button of the
detector to be the master, until the
Green light has flashed 3 times.
The Red light will then start flashing
to indicate its in Pairing mode.
(60 seconds maximum)
Step 4.
Learn in a detector
Press & hold the test button of a slave
detector, until the Green light has
flashed 2 times.
The Red light will then start
flashing as it tries to learn
The Green light will flash 3 times
to indicate it has paired.
Repeat Step 4, on all other detectors
until they have been paired.
Step 2.
Clear Memory
Press & hold the test button until
the Green light has flashed 4 times.
The Green light will then flash back
3 times slowly.
This must be done on all detectors
before Pairing.
Step 5.
Wait 60 second before testing
Step 6.
Testing
Press the test button (for less than 1
second) on one of the detectors.
Within 20 seconds all detectors paired
together should also activate.
Note. The hush button can be pressed
on each detector, without affecting the
wireless interlink test.
Step 1.
Power On
Remove the back and plug the
battery lead into the matching
socket.
Test/ Hush
Button
I ndicator
Light
85dB
Sounder
Note. AJ-718 heat detectors
can also be paired with
AJ-765 smoke detectors and
AJ-R106 remote.