Instruction Manual

STEP 1:
Use an impact drill and 8mm nut-setter to remove
the driver side tail lamp
4 5
STEP 2:
Unplug the OEM connector and install the
P-BUA-F150-21 harness between the OEM
connectors
STEP 3:
Route the harness down the tail lamp cavity and
re-install the driver side tail lamp
STEP 4:
Use an impact drill and 10mm nut-setter to install
a compatible backup alarm on the underside of
the vehicle
Note: (2) 10mm TEK screws are provided with
the compatible backup alarm
STEP 6:
Test the backup alarm
STEP 5:
Plug the backup alarm connector into the mating connector on the P-BUA-F150-21 harness.
Secure any excess wiring with cable ties. Use diagonal cutters to remove excess cable tie
material.