Specifications

3. REPAIR SPECIFICATIONS
Item n°. : W1404621 Page 3-1 Version 01.02
3.1. Disassembly instructions
This section provides the procedure for dismantling the unit to access the various parts.
Check the following points before you dismantle the unit:
- MAGLIFE C PLUS. must be off, and the mains cable must be disconnected,
- all the cables on the front must be disconnected,
- dismantle the unit on an antistatic mat.
F
Note: the figures in brackets refer to the exploded view of the unit.
3.1.1. Disassembly the front plate (x)
Turn the device over, so that the back of the device is before you. Unscrew the 6
screws (x) situated on the sides of the device.
Turn the device over again. Remove the last screw on the top of the back of the
device, but you must carefully support the front plate so that it can't fall brutally.
Disconnect all cables linking the components of the front panel and the rear panel
Place the front panel on a carpet. Now, you can remove the following parts :
- the « left keypad » board,
- the « right keypad » board,
- the speaker,
- the « PC interface » board,
- the CPU/VGA 486/586LCD board,
- the internal screen coveri.
a) « left keypad » (x) board
Unscrew the 8 screws (x) on the board and disconnect the connector from the
board.
b) « right keypad » (x) board
Unscrew the 4 screws on the board and disconnect the connectors from the
board.
c) Speaker (x)
Remove the connector on the « PC nterface » board and unstick the speaker.