Specifications

1. OPERATION
Item n°. : W1404621 Page 1-6 Version 01.02
1.3. Starting up and screen display
Connect the power supply unit provided with the device to MAGSCREEN via input (12) on the
rear.
Make sure that MAGLIFE C PLUS. is on (indicator on the left-hand side of the ON/OFF button
of MAGLIFE C PLUS. is on) and that the two units are correctly connected.
After a few seconds, indicator (1) will go on to show that the device is on.
G
Important: MAGSCREEN can only operate if MAGLIFE C PLUS. is on. The
On/Off control of MAGSCREEN is controlled by that of MAGLIFE C
PLUS.
After a few more seconds, the following initialisation message will be displayed:
MAGSCREEN Version XX.XX
Initialising
Please wait ...
After that message, MAGSCREEN will display a screen identical to that of MAGLIFE C PLUS.
(see section 4.11. of the MAGLIFE C PLUS. User's Manual, item code W1403956). The audio
information transmitted by MAGLIFE C PLUS. is also transmitted by MAGSCREEN via the
loudspeaker (10) (see section 4.12. of MAGLIFE C PLUS. User's Manual, item code
W1403956).
At the same time, a symbol showing that the connection between the two devices is active will
be displayed in the status bar on the bottom of the screen.
F
Notes:
- on MAGLIFE C PLUS., the status bar will take on the same
configuration as on MAGSCREEN.
- if the versions of the two devices are not compatible, the
initialisation message disappears and is replaced by a
message stating "Communication Problem" and the system
remains under the control of MAGLIFE C PLUS.
- pressing keys (6) and (7) simultaneously brings up the
MAGSCREEN version number in the status bar for 5
seconds.