Instruction manual

60 SBC-400 User's Manual
Installing PC/104 modules
The SBC-400's PC/104 connectors give you the flexibility to attach
PC/104 expansion modules. These modules perform the functions
of traditional plug-in expansion cards, but save space and valuable
slots. Modules include:
• PCM-3290 GPS Module
• PCM-3810 Solid-state Disk Module
• PCM-3820 High Density Flash Disk Module
• PCM-3110 PCMCIA Module
• PCM-3111 Secondary PCMCIA Module
• PCM-3610 Isolated RS-232 and RS-422/485 Module
• PCM-3660 Ethernet Module
• PCM-3718 30 KHz A/D Module
• PCM-3724 48-channel DIO Module
• PCM-3910 Breadboard Module
To install these modules on the SBC-400 is a quick and simple
operation. The following steps show how to mount the PC/104
modules:
Step 1 Remove the SBC-400 from your system paying
particular attention to the safety instructions already
mentioned above.
Step 2 Make any jumper or link changes required to the CPU
card now. Once the PC/104 module is mounted you
may have difficulty in accessing these.
Step 3 Normal PC/104 modules have "male" connectors and
mount directly onto the main card. However, for
reasons that ensure better bus matching, the connectors
on the SBC-400 and the PC/104 module are both
"female". For this reason you need to plug-in a "male-
male" adapter connecter (included with the SBC-400).
Please refer to the following PC/104 module mounting
diagram on the following page. After this is in place
you then have the correct mounting connector to accept
your PC/104 module.