Specifications

Installing the PC/104-Module

The PCM-4330 is installed in a PC/104 system and takes over the function of the

CPU. Please observe the following guidelines for the installation of the module:

2.1.4

8 Switch off the computer system.

8 Remove the power cord.

8 Remove the cover or housing of the computer system

8 If a PC/104-CPU-board, VGA graphics adapter, IDE-hard disk or floppy disk

controller is installed in the system, remove it. The PCM-4330 comprises all

functions of these boards.

8 Carefully install the PCM-4330 in the PC/104 system. The board features four

holes for safe fastening and a connector for the installation on a PC/ 104 bus.

8 Connect all cables and connectors with the appropriate interfaces (system,LPT1,

COM1, COM2, VGA/LCD, IDE hard disk, floppy disk, and power). See chap-

ter 4.

8 Replace the housing cover and plug in the power cord.

8 Switch on the computer system.

8 Call the Setup-Menu.

Check that jumpers Jp1 and Jp2 and all configuration switches are

set correctly before installation.