Owner's manual

3-12
IMBM-H61B
RS Mode [RS232]
Allows you to congure the serial communications standard of serial port (COM) 9.
Conguration options: [RS232] [RS422] [RS485]
Serial Port 10~13 [Enabled]
Allows you to enable or disable serial ports (COM) 10~13. Conguration options:
[Enabled] [Disabled]
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT). Conguration options:
[Enabled] [Disabled]
Change Settings [Auto]
Allows you to select the Parallel Port base address. Conguration options:
[Auto] [IO=378h; IRQ=5] [IO=378h; IRQ=5,6,7,9,10,11,12] [IO=3BCh;
IRQ=5,6,7,9,10,11,12]
Device Mode [STD Printer Mode]
Allows you to set the Printer port mode. Conguration options: [STD Printer Mode]
[SPP Mode] [EPP-1.9 and SPP Mode] [EPP-1.7 and SPP Mode]
3.4.9 APM
ErP Ready [Enabled]
This item allows user to switch off some power at S5 to get the system ready for
ErP requirement. When set to Enabled, all other PME options will be switched off.
Conguration options: [Disabled] [Enabled]
AT/ATX Power Type [ATX Mode]
Allows you to set the AT/ATX power type. Conguration options: [ATX Mode] [AT
Mode]
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system
state was before the AC power loss.
Power On By PCI [Disabled]
[Disabled] Disables the PCI devices to generate a wake event.
[Enabled] Enables the PCI devices to generate a wake event.
Power On By PCIE [Disabled]
[Disabled] Disables the PCIE devices to generate a wake event.
[Enabled] Enables the PCIE devices to generate a wake event.