User guide

Chapter 3: BIOS setup
3-17
3.6.3 Post Delay Time [3 sec]
AllowsyoutosetthePOSTReportwaittime.Thiscongurationonlyfunctionsin
NormalBootmode.Congurationoptions:[0sec][1sec][2sec][3sec][4sec][5
sec] [6 sec] [7 sec] [8 sec] [9 sec] [10 sec]
3.6.4 Wait for ‘F1’ If Error [Enabled]
When this item is set to [Enabled], the system waits for the F1 key to be pressed
whenerroroccurs.Congurationoptions:[Disabled][Enabled]
3.6.5 Option ROM Messages [Force BIOS]
[Force BIOS] The third-party ROM messages will be forced to display during the
boot sequence.
[Keep Current] The third-party ROM messages will be displayed only if the third-
party manufacturer had set the add-on device to do so.
3.6.6 CSM Parameters
This option controls whether or not CSM (Compatibility Support Module) will be
launched.
Launch CSM [Enabled]
[Enabled] For better compatibility, enable the CSM to fully support the non-
UEFI driver add-on devices, or the Windows UEFI mode.
[Disabled] Disable the CSM to fully support the Windows Security Update and
Security Boot.
NOTE: The following four items appear only when you set Launch CSM to
[Enabled].
Boot Device Control [UEFI and Legacy OpRom]
Congurationoption:[UEFIandLegacyOpRom][LegacyOpRomonly][UEFIonly]
BootfromNetworkDevices[LegacyOpRomrst]
Congurationoption:[LegacyOpRomrst][UEFIdriverrst][Ignore]
BootfromStorageDevices[LegacyOpRomrst]
Congurationoption:[Both,LegacyOpRomrst][Both,UEFIdriverrst][Legacy
OpRomrst][UEFIdriverrst][Ignore]
BootfromPCIe/PCIExpansionDevices[LegacyOpRomrst]
Congurationoption:[LegacyOpRomrst][UEFIdriverrst]