User guide

2-19
Chapter 2: Motherboard information
5. Intel
®
H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~3)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical
drives via Serial ATA 3.0 Gb/s signal cables.
NOTES:
• You must install Windows
®
XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• Due to H61 Chipset limitation, AHCI Mode only works on Windows
®
Vista/
Windows
®
7. Please use IDE Mode on Windows
®
XP.
• ToconguretheSATAtypeinBIOS,clickAdvanced tab > SATA
Conguration> SATA Mode Selection. See section 3.4.3 SATA
Conguration for details.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.4.3SATAConguration for details.
SATA3G_3
GND
RSATA_RXP3
RSATA_RXN3
GND
RSATA_TXN3
RSATA_TXP3
GND
SATA3G_1
GND
RSATA_RXP1
RSATA_RXN1
GND
RSATA_TXN1
RSATA_TXP1
GND
SATA3G_2
GND
RSATA_RXP2
RSATA_RXN2
GND
RSATA_TXN2
RSATA_TXP2
GND
IMBM-H61A
IMBM-H61A Intel
®
SATA 3.0Gb/s connectors
6. LVDS connector (30-pin LVDS)
This connector is for a LCD monitor that supports Low-voltage differential
signaling (LVDS) interface.
IMBM-H61A
IMBM-H61A LVDS connector
LVDS
PIN 1
Backlight Control for DC mode
GND
LVDS0_CLK+
GND
LVDS0_D0+ LVDS0_D1+ LVDS0_D2+ LVDS0_D3+
EDID_CLK
LVDS1_D0+ LVDS1_D1+ LVDS1_D2+ LVDS1_D3+
GND
LVDS1_CLK+
LVDS Panel Enable LVDS VCC LVDS0_CLK- LVDS VCC LVDS0_D0- LVDS0_D1- LVDS0_D2- LVDS0_D3- EDID_Data LVDS1_D0- LVDS1_D1- LVDS1_D2- LVDS1_D3- LVDS VCC LVDS1_CLK-