User Manual

SubCompact Board GENE-U15B
Chapter 2 Quick Installation Guide 2-7
2.4 List of Jumpers
The board has a number of jumpers that allow you to configure your
system to suit your application.
The table below shows the function of each of the board's jumpers:
Label Function
JP1 LVDS-Inverter Voltage Control Selection
JP2 LVDS-LCD +5V/+3.3V Selection
JP3 LVDS-Inverter +5V/+12V Selection
JP4 COM2 +5V/+12V/Ring Selection
JP5 Touch Panel 4/5/8-Wire Selection
JP6 CPLD Reset Selection
JP7 Auto Power Button / Front Panel Button Selection
JP8 Clear CMOS
JP9 CRT Always On Disable/Enable
2.5 List of Connectors
The board has a number of connectors that allow you to configure
your system to suit your application. The table below shows the
function of each board's connectors:
Label Function
CN2 DDR2 SODIMM Connector
CN5 LVDS Panel Connector
CN6 LVDS-Inverter +5V/+12V Connector
CN7 LAN Connector
CN8 Touch Panel Connector
CN11 (COM1) RS-232 Serial Port Connector
CN12 (COM2) RS-232/422/485 Serial Port Connector
CN13 Mini Card Slot