Instruction manual

54 Gene-4310 User Manual
Power Management
This option allows you to select the type (or degree) of power
saving for Doze, Standby, and Suspend modes.
This table describes each power management mode:
Max Saving Maximum power savings. Only Available for
SL CPUs. Inactivity period is 1 minute in
each mode.
User Define Set each mode individually. Select time-out
periods in the section for each mode,
below.
Min Saving Minimum power savings. Inactivity period is
1 hour in each mode (except the hard
drive).
Doze Mode
After the selected period of system inactivity, the CPU clock
throttles to a small percentage of its duty cycle — between 10
percent and 25 percent for most chipsets. All other devices still
operate at full speed.
Standby mode
After the selected period of system inactivity, the CPU clock stops,
the board drive enters an idle state, and the L2 cache enters a
power-save mode. All other devices still operate at full speed.
HDD Power Down
After the selected period of drive inactivity, any system IDE
devices compatible with the ATA-2 specification or later power
manage themselves, putting themselves into an idle state after the
specified timeout and then waking themselves up when accessed.