Instruction manual

Chapter 2 Installation 17
Installing SDRAM (SODIMM)
System Memory
The reverse side of the Gene-4310 contains a socket for 144-pin
dual inline memory module (SODIMM). The socket uses 3.3 V
unbuffered synchronous SDRAM and is available in capacities of
16, 32, 64, or 128 MB. The socket can be filled in the SODIMM of
any size, giving your GENE-4310 single board computer between 16
and 128 MB of memory.
Supplementary information about DIMM
Your Gene-4310 can accept regular PC-100 SDRAM SODIMM
Module(with or without parity).
Single-sided modules are typically 16 or 64 MB; double-sided
modules are usually 32 or 128 MB.
Memory Installation Procedures
To install SDRAM, Slowly slide the SDRAM module along the
plastic guides on both ends of the socket. Then press the SDRAM
module into the socket, until you hear a click. This is when the two
handles have automatically locked the memory module into the
correct position of the soDIMM socket. To take away the memory
module, just push both handles outward, and the memory module
will be ejected by the mechanism in the socket.