User guide

Network Appliance FWS-2200
Stop bits indicate the end of a serial data packet. (A start bit indicates the
begin
ning).
The standard setting is 1 stop bit. Communication with slow devices may
require more than 1 stop bit.
None DefaultFlow Control
Hardware RTS/CTS
Flow control can prevent data loss from buffer overflow. When sending
data, if the receiving buffers are full, a ‘stop’ signal can be sent to stop the
data flow. Once the buffers are empty, a ‘start’ signal can be sent to
re-start the flow. Hardware flow control uses two wires to send start/stop
signals.
Disabled VT-UTF8 Combo Key
Support
Enabled Default
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Disabled DefaultRecorder Mode
Enabled
On this mode enabled only text will be send. This is to capture Terminal
data.
Disabled DefaultResolution 100x31
Enabled
Enables or disables extended terminal resolution.
80x24 DefaultLegacy OS Redirection
Resolution
80x25
On Legacy OS, the Number of Rows and Columns supported redirection.
Chapter 3 AMI BIOS Setup 3-23