User's Manual
Chapter 2 – Getting Started 10
Rugged Tablet Computer RTC-700B
2.2 NotesBeforeUse
Before using your device, please read through the following instructions
z Use only the power adapter that comes with your device. Using a different
power adapter may cause damage.
z The AC cable is designed for the RTC-700B only
z This product is intended to be supplied by a Listed Power Adapter or DC
power source, rated 12Vdc, 3A minimum, Tma = 40°C. Please contact
AAEON for further assistance.
z Using a power outlet is the best way to charge your device (refer to section
1.2 for the adapter’s voltage output and acceptable input)
z When using the device for the first time, fully charge the battery for up to 8
hours. If the device is inactive, charging the battery once per month is
recommended to prevent deterioration.
z There are two batteries in the RTC-700B: Battery 1 is internal while battery
2 is swappable by the user (both batteries can be monitored at the title bar).
Charge the device once battery 1 drops below 20%
z Always allow your battery to be fully charged before use. Calibrating the
battery before use is also highly recommended.
z To prolong battery life, allow a fully charged battery to discharge more than
95% before recharging
z Ensure that the battery cover is properly secured by manually pushing the
pin to lock position.
z The RTC-700B CANNOT be charged via an USB connection.
z The IP65 waterproof protection may get damaged when subjected to
shocks greater than levels tested in MIL-STD-810G Method 516.6
Procedure IV. The protection may also be affected if the rubber connector
fails to cover or close firmly.