User's Manual

User Manual Albert / MTPT10
USER MANUAL
P A G E |26
 If you connect the power supply, a “Connect” sound is played and the battery icon on
the system bar indicates that charging is in progress.
 If you disconnect the power supply, a “Disconnect” sound is played and the “battery
charging” icon on the system bar changes to the icon showing battery life.
 If the battery charge goes down to 1-2%, the Albert /MTPT10
automatically switch off.
When the device is OFF:
 If you connect it to the power supply, the MSR LED goes ON and the device starts
charging (but remains OFF)
 If you disconnect it from the power supply, the MSR LED goes OFF and the device stops
charging (and remains OFF).
 You can switch the Albert /MTPT10 ON by pressing and holding down the power button
for about 4 seconds, until the MSR LED light (on the top-left yellow corner) turns on, at
which point the power button should be released. If the device was charging while OFF,
the MSR LED would already be a solid yellow and in this case, the power button should
be released after the MSR LED has turned briefly off and back on again.
When the device is ASLEEP:
 If you connect it to the power supply, the device plays a “Connect” sound after a few
seconds’ delay and wakes up. It might prompt you for a password. The “battery
charging” icon is displayed on the system bar.
 If you disconnect it from the power supply, a “Disconnect” sound is played after a few
seconds’ delay. Charging stops and it wakes up. It might prompt you for a password.
 Wake it up by pressing the power button once. You might be
prompted to provide a password (after which the device shows
the screen that was being displayed prior to its going to SLEEP).