Instruction manual

NOTICE: There is no warranty on kits. It is your responsibility to install the board and lights. Kits cannot be returned. This kit can
consume a lot of current. Be careful if you plan to use a battery source that is capable of delivering a lot of current. Contact a
professional if you need assistance. Hyperdyne Labs assumes no responsibility for the misuse of this kit. Night flying can be
dangerous. User accepts all liability of using this kit in their plane and the responsibility of flying at night.
9
After you are done, you can put some hot glue on the solder points to strengthen the
connection. Now you are done with the wing LED hookup!
Going back to the main ribbon cable, the next LED to connect is the X-port activity LED.
The ribbon wires next on the cable are colored orange then yellow. The + lead is
soldered to the yellow wire and the – lead is connected to the orange wire.
The last LED to connect is the front white LED cluster. Take the cluster and turn it over.
The blue wire is connected to the center solder area and the – lead is connected to any of
the 4 small solder pads on the outside of the cluster. Here the solder ring in the center is
not used. Again you can use hot glue to strengthen the connection after soldering.